DVTELL Ioimage trk-101 Instrukcja Instalacji Pobierz pdf (Strona 15)

Introduction

Item

Description

RESET Button

For setting the unit factory defaults, setting Technician mode, or resetting the

unit.

LEDs

The LEDs indicates several status conditions:

 Off: The unit is resetting.

 Flashing green (300ms intervals): The firmware is booting.

 Flashing green (one second intervals): The firmware has booted

successfully, the encoder is connected to the network, and unit is

operating normally.

 Steady red: Failure in the first phase of the boot. Requires resetting the

unit.

 Flashing red: Failure in the second phase of the boot. Requires

resetting the unit.

 Steady yellow: Reset button was pressed for 5-15 seconds and entered

Technician mode. Requires resetting the unit.

 Flashing yellow (500ms intervals): The unit is in Factory Default mode.

To enter this mode, press the Reset button for 15-30 seconds. The LED

changes from steady state to flashing after five seconds. The unit’s

firmware returns to the factory defaults. When finished, the LED

displays flashing green.

Note:

If the LED is pressed for more than 30 seconds, it will flash red,

indicating an error. In this case, disconnect the unit and reboot.

TR+/TR-

RS485

Two-pin terminal block connector to connect an RS-485 cable from and control

a PTZ camera.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 34 35

Brak uwag

DVTELL Ioimage trk-101 Instrukcja Instalacji Strona 15